Are you aware that there are two available options for charging your XPENG P7 AWD Performance? They are using a regular wall plug or a charging station. However, if you're on the road, using a wall plug is not viable, so public charging can only be done through a charging station. The charging speed for your electric vehicle (EV) relies on the type of charging station or EVSE used, as well as your EV's maximum charging capacity. Please refer to the table below, which illustrates all the available charging options for your XPENG P7 AWD Performance, accompanied by an estimate of the time required to charge the battery from empty to full.
Europe
Charging an electric vehicle (EV) across Europe can differ depending on the country you are in. Some European countries make use of one phase connections as the primary method of charging, while others rely heavily on a three-phase connection. The table below outlines all possible ways to charge an XPENG P7 AWD Performance. However, some charging modes may not be available in certain countries. Thus, it is recommended to check with local electric vehicle charging networks to determine which options are available to you.
Type 2 (Mennekes - IEC 62196)
Charging Point
Max. Power
Power
Time
Rate
Wall Plug (2.3 kW)
230V / 1x10A
2.3 kW
42h30m
11 km/h
1-phase 16A (3.7 kW)
230V / 1x16A
3.7 kW
26h30m
18 km/h
1-phase 32A (7.4 kW)
230V / 1x32A
7.4 kW
13h15m
35 km/h
3-phase 16A (11 kW)
400V / 3x16A
11 kW
9 hours
52 km/h
3-phase 32A (22 kW)
400V / 3x16A
11 kW †
9 hours
52 km/h
† = Limited by on-board charger, vehicle cannot charge faster.
Fast Charging (10 → 80%)
Fast charging is essential to expanding the range of your journey by adding an optimal amount of distance in the shortest possible time. When the battery reaches an 80% state-of-charge, the charging power will significantly decrease. Therefore, regular fast charging usually does not go beyond 80% SoC. The speed of charging an electric vehicle depends on both the charging station used and the maximum charging power that the EV can handle. The table below provides a comprehensive overview for fast charging the XPENG P7 AWD Performance on our charging station.
Max. Power: maximum power provided by charge point
Avg. Power: average power provided by charge point over a session from 10% to 80%
Time: time needed to charge from 10% to 80%
Rate: average charging speed over a session from 10% to 80%
Note: The given energy consumption and range data, influenced by moderate driving and climate conditions, might not match actual driving experiences. Pricing info could vary across regions or markets. This site's content is for only informational purposes, not specifc advice for you.
Contact Electrly
See all photos